glass 1989 LIS Manuel D'emploi page 10

All the whirlpool bath components require frequent servicing. Follow the instructions
below with the greatest attention to avoid damaging the gloss of the acrylic and metal
parts.
• Use soft cloths and neutral liquid detergents that are not abrasive to clean the bath.
Do not use synthetic fibre cloths, scouring pads, metal pads, abrasive detergents,
GB
liquid or solid, alcohol, acids for domestic use, acetone or other solvents, which
damage surfaces.
• To ensure that the bath maintains its gloss throughout years, do not use water over
60° C
• While the whirlpool is operating, avoid using foaming products, vegetable preparations
and bath salts that are not completely soluble (potentially abrasive).
• Install a water softening system to eliminate scale.
• Light scratches or cigarette burns can be eliminated by sanding the part with very
fine sandpaper (grain 1200); it is advisable to wet the part continuously with water
to limit scratches. Use a polish to restore gloss.
• If the water is slow to drain away, check that in the drain outlet is clean.
It is advisable to clean all the whirlpool water circuit periodically (2/3 times a year)
according to the instructions below.
a. Fill the bath with water, covering completely the jets, add the liquid disinfectant in
the quantity stated on the bottle of the product and start the whirlpool for at least 15
minutes.
b.Empty the bath, fill it again with clean water and start the whirlpool for another 5/6
minutes.
c. Empty and dry the bath.
• Maintenance and adjustment works must be carried out by experts only.
• All service covers must be appropriately reinstalled after maintenance
works.
If the above operations do not solve the problem, contact your nearest service
centre.
ROUTINE AND SPEcIAL MAINTENANcE
10