Electrical Connections; Equipotential Connection - glass 1989 LIS Manuel D'emploi

- When making the connection to the electrical mains, you must install a bipolar switch,
upstream of the power supply box, with contacts opening by at least 3 mm, and suitable
for 220/240 V 16 A.
- The product must be connected to an electrical system as the current
specifications.
- The appliance should be supplied through a residual current device (RCD) with a
rated tripping current not exceeding 30 mA.
GB
- The bearing structure of the product is metallic. Consequently, an efficient earthing
system is required, with sensitivity meeting the relevant standards.
Connect the power supply of the system inside a connection box with the minimum
protection level IPX5 (figure 1).
Using an 7 mm wrench, connect the wire of the home's equipotential circuit (A) with
a square M5 nut (Q), indented washer (R) and a hexagon M5 nut (D) to the tub frame
(V) as shown in the figure 2.

ELEcTRIcAL cONNEcTIONS

cONNEcTING THE TUB
TO THE HOME'S ELEcTRIcAL MAINS

EQUIPOTENTIAL cONNEcTION

R
Q
D
A
V
8
FIGURE 1
FIGURE 2