Installation; Rear Spacers - Electrolux EUF1900AOW Notice D'utilisation

6 www.electrolux.com

3. INSTALLATION

WARNING!
Refer to Safety chapters.
3.1 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance.
Climate
class
SN
N
ST
T
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Authorised Service Centre.
3.2 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in front.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
If you place the appliance on a stand:
1. Unscrew the foot of the door hinge.
2. Screw the spare foot, found in the
bag with the egg tray, into the
cabinet.

3.3 Rear spacers

In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
1. Fit the spacers into the holes. Make
sure that the arrow (A) is positioned
as shown in the picture.
1
A
2. Turn counter-clockwise the spacers
through 45° until they lock into place.
3.4 Location
It must be possible to
disconnect the appliance
from the mains power
supply; the plug must
therefore be easily
accessible after installation.
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely
around the back of the cabinet. To
ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the cabinet
and the wall unit must be at least 100
mm . Ideally, however, the appliance
should not be positioned below
overhanging wall units. Accurate levelling
2
45°
45°
2