Publicité
Les langues disponibles
Les langues disponibles
AVAILABLE ACCESSORIES
12" Crevice Tool
A
Clean in corners and other tight spaces or
reach baseboards and ceilings with this slim
crevice tool.
Pet Multi-Tool
B
Two tools for cleaning tough pet messes:
first, a stiff bristle brush for cleaning stuck-on
debris. Then remove the bristles to reveal an
upholstery tool for cleaning stubborn pet
hair.
Anti-Allergen Dust Brush
C
Features specially designed nylon fiber
bristles for removing fine dust and allergen
particles from the most delicate surfaces.
Onboard Motorized Pet Tool
D
Compact motorized brush powerful enough
to remove deeply embedded allergens,
dirt, and pet hair from multiple surfaces.
Stores onboard for your convenience. Latch
connection clicks this tool into place on
handle or wand.
Under-Appliance Wand
E
Pivoting wand that extends to clean under
appliances and on top of furniture.
Pet Power Brush
F
Picks up pet hair and loose debris. Powerfully
deep cleans dander out of upholstery and
other surfaces.
Upholstery Tool
G
Perfect for large-particle pickup, dusting,
and removing pet hair and lint from furniture
and other upholstered surfaces.
NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's
configuration. To order additional accessories, visit sharkaccessories.com.
sharkc le a n.com
Vacuum is not picking up debris. No suction or light suction.
A
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
(Refer to Checking for Blockages section for more information.)
B
• If any hair, string, or carpet fibers are wrapped around the brushroll, extend cleaning time to
allow self-cleaning brushroll to remove them.
– Use CARPET/LOW PILE mode on a bare floor surface, a low-pile carpet, or a small area rug.
This will allow the self-cleaning brushroll to remove the hair wrap and send it to the dust cup.
– If some fibers remain wrapped around the brushroll after continued use, remove the
brushroll garage lid and carefully clear the debris from the brushroll. See Cleaning the
Brushroll section for more information.
Vacuum lifts area rugs.
• Make sure surface selector switch is set to Hard Floor (setting I).
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
C
Brushrolls do not spin.
• If the brushroll indicator light turns red, immediately turn off and unplug the vacuum. Remove
pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum, and turn on
power.
• With the power on, recline the handle, which will automatically turn on the brushrolls.
D
• Ensure that the surface selector switch is set to Carpet (setting II) for brushrolls to spin.
Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning Filters).
E
3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 1 hour.
5. Plug in vacuum and turn it on.
F
G
NOTE: If the vacuum still does not run properly, please go to sharkclean.com/customersupport for the latest FAQs, troubleshooting
tips, and more.
For all other issues, please call Customer Service 1-800-798-7398.
TROUBLESHOOTING
s ha rkc l ea n.co m
Publicité
