Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Push against the seal area of the front frame to push the oven
into the cabinet until the back surface of the front frame
touches the front wall of the cabinet.
A. Shipping foot
3. Push oven completely into the cabinet and center the oven
into the cabinet cutout.
NOTE: If you have model KEBK171B, KEBK101B,
KEBK276B, KEBK206B, KEBS179B, KEBS109B, KEBS277B,
KEBS279B, KEBS207B, KEBS209B, KEBU109B or
KEBU209B, proceed to Step 5.
4. Insert the grommet into the mounting rail hole using a flat-
blade screwdriver. Insert the screwdriver into the grommet
and turn ¹⁄₄ turn counterclockwise. Make sure the grommet
stays in position.
IMPORTANT: If the grommet is not installed, the front frame
will be damaged.
A
B
C
A. Mounting rail
B. Mounting rail hole
C. Grommet
5. Securely fasten oven to cabinet using the # 8–14 x 1" screws
provided. Insert the screws through hole in the grommet. Do
not overtighten screws.
12
6. On models with the foot positioned with the long side of the
foot facing toward the top of the oven, the oven vent is taped
to the side of the oven. See the following instructions to
install.
Align vent tab (B) with oven frame (A) as shown.
Using one #8-18 x ³⁄₈" screw (D) on each side of the vent
tab (B), fasten the vent securely to the oven.
D
A. Oven frame
B. Vent tab
C. Oven vent
D. #8–18 x
7. On models with the foot positioned with the short side of the
foot toward the top of the oven, the bottom vent trim must
also be installed. See the following instructions to install.
Position the bottom vent trim (B) on the vent (C).
Install the bottom vent trim (B) to the vent (C) using two
¹⁄₄
#8–18 x
" screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8–18 x
used on each side.
A. #8–18 x ¹⁄₄" screw
B. Bottom vent trim
C. Vent
A
B
C
³⁄₈
" screws
¹⁄₄
" screw is
A
B
C
Publicité
Table des Matières
