Circuit Board Error Code; Factory Reset - Jaga BRIZA 12 Instructions D'installation

2.3. CIRCUIT BOARD ERROR CODE
1
2.4. FACTORY RESET
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again. The blue LED will light up, followed
by the green LED 2 seconds later and the red LED 4 seconds later.
Release the buttons as soon as all 3 LEDs are flashing .
3. The controller will return to the Factory Default settings, all LEDs
will flash for 8 seconds .
JAGA NV | BRIZA 12 - JDPC.002 | MANUEL | 05.07.2021 | V.08
Check the water temperature sensor
Check the room temperature sensor
-
EN
45