Jaga BRIZA 12 Instructions D'installation page 42

C.1.2. With control pannel -
The device is controlled via auto-change-over. The unit starts when the preset water temperature is
reached. The user can temporarily select another mode manually.
Auto-change-over. The unit starts at the last selected speed(1, 2 or 3), if the water temperature >
28 ̊ C .
Auto-change-over. The unit starts at the last selected speed(1, 2 or 3), if the water temperature <
18 ̊ C .
The unit automatically starts a new cycle if the preset temperature is reached.
- - 3 Speeds . The unit can run at 3 speeds.
Control panel operation :
Press and hold to switch modes (± 3sec).
3"
Standby
Manually changing the fan speed : short press
Speed 1
Red LEDs are flashing: the water temperature for heating is too low (< 28 ̊ C ).
Blue LEDs are flashing: the water temperature for cooling is too high (> 18 ̊ C ).
42
DPC.BRC4 / DPC.BRC6
3"
Speed 2
JAGA NV | BRIZA 12 - JDPC.002 | MANUEL | 05.07.2021 | V.08
3"
Standby
3"
Speed 3