Enjoying Multi-Channel Surround Sound; Step 2 The Remote Control; Step 3 Quick Setup; Step 4 Television Operation - Panasonic DVD-S97 Manuel D'utilisation

Enjoying multi-channel surround sound

≥Select "Off" in "HDMI Audio Output" (
WITH COAXIAL IN or OPTICAL IN
Amplifier with a built-in decoder or
a decoder-amplifier combination
COAXIAL IN OPTICAL IN
Coaxial Optical digital audio cable
cable
Do not bend sharply when connecting.
CENTER
OPTICAL
COAXIAL
SUBWOOFER
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
STEP 2
The remote control
∫ Batteries
R6/LR6, AA, UM-3
STEP 3
QUICK SETUP
Turn on the television and select the appropriate video input on the television.
1
TV
TV/VIDEO CH VOLUME
FL SELECT
DIRECT NAVIGATOR PLAY LIST
TOP MENU MENU
ENTER
DISPLAY
RETURN
CONTRAST BRIGHTNESS SHARPNESS COLOR
To change these settings later
SUBTITLE AUDIO ANGLE/PAGE SETUP
Select "QUICK SETUP" (
STEP 4
Television operation
Point the remote control at the television
While pressing [Í
TV]
e.g., 01: [0] [1]
Manufacturer and Code No.
Panasonic
National 01, 02
QUASAR
FISHER 10
GE 05
GOLDSTAR 15, 16, 17
Test by turning on the television and changing channels. Repeat the procedure until you find the code that allows correct operation.
≥If your television brand is not listed or if the code listed for your television does not allow control of your television, this remote control is not compatible
with your television.
page 17, "HDMI" tab).
≥You cannot use DTS Digital Surround
decoders not suited to DVD.
≥Even if using this connection, output will be
only 2 channels when playing DVD-Audio.
To enjoy multi-channel surround sound,
connect with 5.1 ch AUDIO OUT terminals
( right) or HDMI terminals (
≥Change "PCM Digital Output",
"Dolby Digital", "DTS Digital
Surround"
( page 16,"Audio" tab ).
Back of the unit
5.
≥Insert so the poles (i and j) match those in the
remote control.
≥Do not use rechargeable type batteries.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
2
DVD
SETUP
Power ON. Shows QUICK
SETUP
screen.
page 17, "Others" tab).
(You can use this unit's remote control to operate your television.)
, enter the code with the numbered buttons.
HITACHI 12
JVC 11
LG 15, 16, 17
MAGNAVOX 03
MITSUBISHI 13
PHILIPS (RC-5) 03
Amplifier
WITH AUDIO IN 5.1ch
To obtain maximum performance of DVD-Audio multi-channel linear PCM
sound, this connection is recommended.To enjoy digital multi-channel
surround sound, connect to an amplifier with HDMI terminals. (
COAXIAL IN
CENTER SUBWOOFER
page 6)
CENTER
OPTICAL
SUBWOOFER
Mishandling of batteries can cause electrolyte
leakage which can damage items the fluid contacts
and may cause a fire.
Remove if the remote control is not going to be used
for a long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (
avoiding obstacles, at a maximum range of 7 m (23
feet) directly in front of the unit.
3
RETURN
ENTER
Follow the
message and
make the settings.
RCA
SAMSUNG
SANYO
SHARP
SONY
SYLVANIA
SURROUND FRONT
(L) (R) (L) (R)
Audio cable
Connect cables to
terminals corresponding to
the speakers you have
connected.
≥Change "Speaker
SURROUND FRONT L/L
L L
Settings" (
"Audio" tab).
R
FRONT R/R
5.1ch 2c 2 2 h
AUDIO OUT
4 5
SETUP
ENTER
Press to finish Press to
QUICK
exit.
SETUP.
TV
TV/VIDEO CH VOLUME
05 THOMSON
14, 18, 19 TOSHIBA
10 ZENITH
06, 07
08
03
page 6)
page 16,
page 8),
TV operation
05
09
04
7
7