Erv Core Washing Instructions - Fantech FIT 70E Manuel D'installation Et D'utilisation

Filters and ERV core washing instructions
For proper maintenance of your energy recovery core please follow these instructions
1
5
6
8
11
2
3
7
10
9
1 To remove the door, remove locking screw
and washer on the side of the unit.
2 Remove both filters.Wash filters in warm
soapy water then rinse and let dry.
3 Rotate the metal plate holding the ERV core
in place.
4 Remove the core from the unit.
5
With one of your core's air inlets facing
down, place it in a large sink, bathtub, or
shower.
6 Pour clean tap water through the face of the
core facing upwards until it runs clear.
Ensure the entire surface is rinsed.
7 Rotate the core so that its other air inlet is
facing down and repeat step 5.
8 With plates still oriented vertically allow the
core to dry, normally 2-3 hours.
9 Slide back the core into the system making
sure that the arrow points to the motors.
Rotate the metal plate holding the ERV Core
in place.
10 Replace the filter.
11 Close door and secure with locking screw
and washer.
21