Himolla MOSEL 8533 Mode D'emploi page 13

Always follow the safety instructions on pages 5 and 6!
Putting the battery pack into service and charging it:
The battery pack has a sleep or silent mode in order to be protected from
discharging during transport and storage. If only one light-emitting diode
shines green (hereinafter referred to as LED) after activating the battery
pack, it absolutely has to be charged with the charging station included in
the scope of delivery before mounting the
into operation of.
1. Press the black button to activate .
2. The LEDs show the battery pack charge level.
- 4 green LEDs - the battery pack is fully charged.
- 1 red LED and a beep - the battery pack has to be charged.
3. Connect the mains supply cable to the charger.
4. Connect the mains plug of the charger to the outlet.
5. For charging the battery pack put it on the charger and the
charging process starts automatically.
6. Connect the battery pack to the
of the himolla product can be used by operating the control panel.
WARNING:
Check each time before you use the battery
pack the charger, the cable and the plug, but only if the power supply is cut
off. Should you notice any damage to the charger, the external cable or the
battery pack, the device must no longer be used.
himolla
product and putting it
himolla
product - all functions
2 3
1
5
EN
4
6
13