Blomberg DUS 2040 X Mode D'emploi page 7

Usage Method
Your aspirator may operate to discharge the sucked air to outside medium (by being
connected to a stack) and may also operate in compliance with internal recirculation (with
carbon filter).
All kitchen aspirators operate in a more efficient manner with being connected to a stack.
However, the operation of the aspirator at the internal recirculation position may prove to be
more economical during winter for not disharging the heat in the medium to outside.
Usage With Stack Connection
Please open the filter protection cover of the aspirator.
Put the selective switch on the DUCTING position (Figure 2).
There are connections on and at the rear side of your aspirator for discharging air to outside in
order to be able to make connection to the stack (Figure 3).
Please install the 120 mm diameter tube connection part, which is being furnished together
with your aspiratorin such a manner just to be fit on its place for the hatches of the tube
connector. Please do not interfere anyway with the blind cap, which is present at the rear outlet
under such condition.
Please dismantle the blind cap from the where it is put and please install it to the top, in case
you want to make a connection from the rear. Please fit the tube connection part on the place of
the blind cap.
Please never connect the stack connection of the aspirator while you perform the necessary
procedures to a stack, which is being used for other purposes.
Usage Without Stack Connection
(With Carbon Filter)
Please take the aluminum filters out.
Please put the selective switch on the RECYCLING position (Figure 2). Under such condition
the fitting of the carbon filter to the aspirator is needed. Please fit the carbon filter after you get
in on the fixing cap (Figure 4).
Please put the aluminum filters on again.
Note: You may obtain the carbon filters from the Authorized Services against payment.
Figure 2 Figure 3 Figure 4
5