Important Safety Instructions - Astralpool Heliox UV MP Manuel D'installation

.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: when installing and using electrical equipment, basic safety precautions
should always be followed, including the following:
READ AND FOLLOW ALL THE INSTRUCTIONS
A yellow-green wire connector marked
a minimum No. 8 AWG for US (UL) and a No. 6 AWG for Canada (CSA)
solid copper conductor between this unit and any metal equipment, metal
enclosures of electrical equipment, metal water pipe or conduit within 5 feet
(1.5 m.) of the unit.
Two bonding lugs marked
chamber suitable for No. 8 AWG (US) and No. 6 AWG (Canada) and
secured to the chamber by paint breaking washer and nut.
(*)
IEC 60417, symbol 5019
This product must be connected to a circuit protected by a ground fault circuit
interrupter.
Pool end use. Do not use this system to a different application for which it
was designed.
The equipment should be installed and handled by truly qualified people.
Current electrical and accident prevention regulations should be followed.
Under no circumstances will the manufacturer be held responsible for the
assembly, installation or start-up, nor any handling or fitting of components
unless they are carried out on its premises.
Check all the electrical connectors are well tightened to avoid false contacts
and their consequent overheating.
Install the control panel so that the cooling grids are not obstructed.
For indoor use only. This unit is not intended for outdoor use.
Prior to the installation or replacement of any system component make sure
it has been previously disconnected from the mains, and there is no water
flow through it. Use only spare parts supplied by AstralPool.
Never remove the lock nut of the quartz sleeve when the water is
recirculating through the UV reactor as it could be expelled and causing
damage.
(*)
is provided on this unit to connect
(*)
are provided on the end flanges of the UV
3