Mounting The Standing Model; Mounting The Suspended Model - WANDERS Black Diamond Mode D'emploi Et D'installation

Follow the instructions given in the previous chapter (Preparation) before installing the stove. Protect the oor
during mounting the stove, and mind your back.

Mounting the standing model

1. Check whether the wall in front of which the hearth is placed is adequately re-proof. Please read the text
in the chapter on 'Fire Safety' on page 24.
2. Check the packaging of the stove and the base. Do not mount a stove or a base that has been damaged in
the box. If there is any damage, please report to WANDERS.
3. Be careful when unpacking the stove and protect the oor while unpacking: the mouth of the tube
underneath the stove has a sharp edge.
4. Remove the glass plate from the hearth to avoid any damage.
5. If you need an extra air supply connection to the hearth please read the section on "Mounting the
connection to the external air supply" on page 26.
6. Protect the oor and carefully turn the stove on its backside.
7. Remove the four screws on the bottom side.
8. Take the base from the box and remove the clipped-on front plate from the base.
9. Fasten the base to the stove with the four screws.
10. Lift the stove carefully in an upright position, and put it in the right place, but mind your back.
11. Connect a separate air supply duct, if necessary (minimum diameter: 100 mm). You can use the connection
at the bottom.
12. Click the front piece of the base back in its place.
13. Fasten the top of the hearth to the wall. Never use any synthetic fastenings.
14. Put the glass plate back on the stove.
15. Then mount the ue gas duct overlappingly.

Mounting the suspended model

1. Check whether the wall in front of which the hearth is placed is adequately re-proof. Please read the text
in the chapter on 'Fire Safety' on page 24.
2. Check the packaging of the stove and the base. Do not mount the stove or the base that has been damaged
in the box. If there is any damage, please report to WANDERS.
3. Be careful when unpacking the stove and protect the oor while unpacking: the mouth of the tube
underneath the stove has a sharp edge.
4. Remove the glass plate from the hearth to avoid any damage.
5. Fasten the suspension clip to the wall. Never use any synthetic fastenings. Be sure to place the clip exactly
beneath the centre of the outlet and to hold the hooks face upward. The fastening bolts should not
protrude more than 10 mm from the wall.
25