Opening The Tv Set (Individual 40/ 46 Selection Led 200) - Loewe DVB - T2/C Twin SL1 Série Instructions De Montage

2. Opening the TV set
The description uses the TV set Individual 40 Selection LED 200 as an example.
Pull out the mains plug!
Remove the connecting leads from the TV set.
Remove the short connecting cable between the tuner connections if present.
Undo and remove the screws indicated by the arrows in the relevant figures and according to the TV set model.
(Proceed in the reverse order to replace the rear panel).
Procedure
Fig. 2
Fig. 3
Fig. 4
Position the TV set in a way that every side is accessible.
Remove the cable cover from the rear of the TV set.
Pull back to detach, and remove from below.
This shows the cable connections with the cable cover deta-
ched.
Under each of the left and right side trims are two retaining
screws (M3 T10 screws) that require removal, see fig. 3.
Remove the magnetically secured trims. Use either your fin-
gernail or a tool, e.g. a plastic card or small suction cup.
The arrows in fig. 3 indicate the screws under the trim on
the left and rights sides of the TV set.
If a loudspeaker is installed under your TV set, it must be
removed.
The loudspeaker prevents access to a retaining screw (for the
operating eye / set front)
Detaching the loudspeaker
Remove the four screws indicated by the arrows in fig. 4.
Remove the loudspeaker towards the rear and detach from
the rubber buffers.
25