Using The Diaper Pail - Munchkin STEP Mode D'emploi

How to Install
FOR DIAPER PAIL REFILL RINGS
1 2
3 4
TO REMOVE THE BAG WHEN FULL: Open the front door and slide
the top of the bag through the cutter located beneath the inner lid.
Tie a knot to close the bag and discard.
Pull the remaining material down and tie a knot at the bottom to create
another bag. At least 3 inches should rest on the floor of the pail.
For best results, empty the diaper pail regularly and keep clean.
6
Pull film out of cartridge, then
1.
down through the center
opening of the refill ring.
Tie a knot at the end to create
2.
a bag and feed it through the
sealing flaps.
Place the ring inside the
3.
opening with the tabs lined
up with the grooves, so that
the ring locks into place.
Pull the bag all the way down
4.
with at least 3 inches resting
on the bottom.
FOR SNAP, SEAL & TOSS BAGS
1 2
TO REMOVE THE BAG WHEN FULL: Open the front door and lift the
inner lid. Snap the plastic ring closed and push it down through the
sealing flaps. Then remove and replace with a new bag.

USING THE DIAPER PAIL

1 2
How to Install / How to Use
Feed the bottom of the bag
1.
through the sealing flaps and
pull down tightly.
Push down to snap the ring
2.
under the locking tabs in all 4
locations.
Open the lid. Roll the used
1.
diaper tightly and push it
through the bag's seal into
the pail.
Close the lid. The opening
2.
will twist automatically to
seal in odors.
7