Conditions Of Guarantee - Kroll KG/UB20 Notice D'utilisation

Attention please - A summary of important points regarding "Kroll Multifuel Oil Burner"
1. Read operating instructions carefully, prior to installing and commissioning the heater.
2. The incorrect adjustment of the burner may destroy the combustion chamber and the heat exchanger; therefore, it is
important that the output is correctly set. In order to avoid condensation, the net temperature of the flue gases (=the measured
temperature of the flue gases in °C minus the inlet temperature of the burner in °C minus the inlet temperature of the burner in
°C) must not drop below a value of 160°C (at space heaters).
3. The burner adjustment must be carried out by a specialist (after-sales service for the burner).
The flames must on no account touch the walls of the combustion chamber.
Clean the combustion chamber and the heat exchanger at least once a year. Have the oil burner checked and serviced at
4.
least annually. Conclude a service contract.
5. Do not switch off at the master switch while heating . Use the device switch instead. Otherwise, the device will be destroyed, as
there will be no after-running of the cooling air blower (when using space heaters).
6. Rectify the cause of defect before unlocking the overheat thermostat (warm air thermostat) or the overload relay.
7. In order to qualify for the guarantee, the device must be installed and commissioned by a specialist. The settings are to be
recorded in a measurement certificate.
8. Please fill out all the points of the guarantee form correctly, sign, and send it to Kroll. Please note that in case of missing
measuring values no guarantee certificate will be used.
9. In case of temperatures below 4°C, the oil should be heated in the reservoir (or in the unit tank respectively). (For the relevant
heating cartridges, please refer to the accessories).
In order to protect the control of the heating please note the charging rate of the burner (if necessary, install an
10.
additional relais).

Conditions of Guarantee:

•
The usual guarantee period granted on our devices cover 12 months after the delivery – the date of the invoice being decisive.
•
The guarantee will only be granted if a regular servicing is carried out at least once a year and in accordance with the Kroll
operating instructions. The results must be recorded in the applicable measurement certificates. It is also required that the
device was correctly commissioned and that this is documented in a detailed measurement certificate.
•
Without the proof of a technically correct delivery, any warranties from the side of the Company Kroll will lapse.
•
Any warranties will equally lapse if EL fuel oil according to the DIN Standard No. 51 603-1 is used at temperature below +4°C
or if winter diesel is used below stipulated temperatures. (It is strictly prohibited to add any petrol). The burners must not be
modified or tampered with under circumstances, and repair work must be carried out by a specialist.
•
If the pump pressure is set at a higher value in order to get the heater started up in case of low ambient temperatures, the
device will be overheated as soon as the ambient and oil temperatures are increasing. This will entail cases of damage,
excluding any warranties.
•
In case of deflagrations, an analysis of the fuel oil is used should be made available, and the installing of the device should be
verified by an expert.
Any use, installation, maintenance that is not effected according to the rules as asserted in the technical
manual, or unauthorized modifications on the original version as delivered from manufacturer leads to
expiration of any right to warranty.
Furtheron our „Conditions of Sales and Delivery" are valid.
Technical modification for product improvement are subject to change without notice.
41