Glatz PALAZZO Style Notice De Montage Et D'utilisation page 22

3.2.7 How to operate the RGBW LED
Turning on the RGB: Press channel key 1. The last colour and dimming
level is used.
Changing the colour: ( there are 8 colours available ): With the light on,
press channel key 1 repeatedly until the colour you want is set.
Increasing the RGB luminosity: Press and hold channel key 2 until the
brightness you want is set.
Reducing the RGB luminosity: Press and hold channel key 3 until the
brightness you want is set.
Starting / stopping the RGB colour cycle: Channel key 4 starts the colour
cycle, press it again to stop the cycle at the current colour. When the colour
cycle is stopped, the brightness can be reduced and increased.
Turning on the white LED to 100%: Press channel key 5.
Turning on the white LED to 25%: Press channel key 6.
Increasing the white LED's luminosity: Press and hold channel key 5 until
the brightness you want is set.
Reducing the white LED's luminosity: Press and hold channel key 6 until
the brightness you want is set.
Turning off the RGB and white LED: Press channel key 7.
3.3 42-channel remote control
The 42-channel remote control works the same way as the 7-channel re-
mote control except that the two round keys can be used to switch between
6 groups. So in principle you have 6 7-channel remote controls in your
hand. The active group is displayed with a red light spot when changing
groups or when a channel key is pressed.