Glatz PALAZZO Style Notice De Montage Et D'utilisation page 17

2.1.5 Assembly of the slide housing
a) ATTENTION: Make sure that you do not get the cables caught or get too
close to the mounting screws. Otherwise you risk damaging the cables
and energising the slide and / or pole.
Proceed as follows:
b) Position the slide housing in such a way that the half moon of the
housing is in the centre of the position of the crank hole or the
emergency release of the motor variant.
c) Take two 60 × 35 Torx screws, insert them in the rear boreholes of the
slide provided for this purpose and tighten them by 2 – 3 turns.
Make sure the cables do not get caught between the screws and the
plastic parts.
- You could use a thin bent wire to bring the cables to the desired
position.
- Now carefully tighten the 60 × 35 Torx screws.
d) Take two more 60 × 20 Torx screws, fasten them at the front part ( half
moon ) of the slide and tighten them. Before doing so, you must check
whether there any cables near the mounting hole. If this is the case,
you must remove them, if necessary.
a)
b)
2.2 Commissioning
After having completely installed and connected the sunshade, all options
must undergo a functional check according to chapter 3 «How to operate».
EN
c) d)