PROMAT 4000877149 Mode D'emploi Original page 10

The LED panel (3) falls under the LED risk group 2!
Do not stare into the light beam and in case of accidental exposure of your
eyes to the light of the LED panel immediately close your eyes firmly and
Charging the Battery
Use the included USB charging cable to connect the charging socket (6) of the
lamp to a suitable USB port or use the included power mains adaptor to connect to
a suitable wall socket.
During charging the battery control light (3) on the side of the lamp indicates the
progress of the charging process.
After charging, disconnect the lamp from the charging cable.
Operation
 The dimming wheel (5) is on the back of the lamp. Turn the dimming wheel
clockwise to turn on the lamp and increase the output of the LED panel (2).
Turn the dimming wheel counter clockwise to reduce the output of the LED
panel. To turn off the LED panel, turn the dimming wheel counter clockwise until
there is an audible click and the wheel snaps into place.
 Press the button (4) to turn the single LED (1) at the end of the lamp on or off.
 The lamp is equipped with a tilting magnetic holder (7) and a hanging hook (8).
With the magnetic holder the lamp can be attached to magnetic objects. Please
keep in mind that the magnetic holder may cause scratches on the surface used
for attachment. Fold out the hanging hook to hang he lamp in a suitable place.
This Place should be solid and sturdy so the hook cannot slip off. This way you
have both hands free for work.
 The lamp is splashproof. Do not expose it to water jets or immerse it in liquids.
Maintenance and Storing
Do not use aggressive chemicals, solvents or abrasives to clean the lamp. Do not
Attention!
turn your head away!
6
Operation