Bimar VC90A.NE Notice D'instructions page 8

Fax +32 030 9904733
I
•
f the supply cord is damaged, it must be replaced by the manufactuer, its service agent or similarly
qualified persons in order to avoid a hazard.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure, do not use it
and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails,
etc.) must be kept out the reach of children because they are potential sources of danger.
• Before connecting the appliance, check that the voltage values shown on the data plate (220-240V~
50Hz) correspond to those of the electricity supply network. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the appliance. In general, the use of adapters or extension cords
is not recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the applian ce.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to
avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the appliance off and ask for professionally
qualified help.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8 24
/
Assembly page 8/24