Additional Transmitters; Temperature Display; Comfort Level - TFA 30.3054 Mode D'emploi

TFA_No. 30.3054_Anleit_03_21
KLIMA-MONITOR – Wireless Thermo-Hygrometer
4. Insert two new batteries 1,5 V AAA. On the display appear the temperature and
humidity and the channel number 1.
5. Close the battery compartment again.
• To connect more transmitters, repeat steps 1 to 5. The correct switch position for
the transmitters 1-8 can be found in the table. 3 transmitters are included, the
basic station is expandable to a total of 8 transmitters (optional).
Switch (D 6)
1 2
down down
down down
down up
down up
up down down
up down up
up up down
up up up
— —
— —
6.2 Installation of the basic station
• Open the battery compartment of the basic station and insert four new batteries
1.5 V AAA, polarity as illustrated.
• All LCD segments will be displayed for about a few seconds.
• Close the battery compartment again.
• The measurements of the installed transmitters will be transmitted to the basic
station. The radio-controlled reception symbol appears.
• If the reception is successful, on the display appear the temperature and humidity
of the respective transmitter, the temperature trend symbol and the symbol of the

comfort level.

• The radio-controlled reception symbol disappears.
• In the display section 4 appears automatically the measured values of the internal
sensor.
20
02.03.2021 18:02 Uhr Seite 11
Function
3 4
down — channel 1
up — channel 2
down — channel 3
up — channel 4
— channel 5
— channel 6
— channel 7
— channel 8
— down °F
— up °C
KLIMA-MONITOR – Wireless Thermo-Hygrometer
• If the values are not received from a channel or if no transmitter is installed, "- -"
appears on the display. Check the batteries and try it again. Check if there is any
source of interference.
• You can start the initialization manually.
• Press the CHANNEL / + button until the arrow appears on the desired channel. If
you want to search for all installed transmitters, select the internal sensor (IN).
• Press and hold the CHANNEL / + button for three seconds.
• The radio-controlled reception symbol appears.
• The basic station will scan the measurements.

6.3 Additional transmitters

• If you have installed more than three transmitters, the measurements for transmit-
ter 4-8 appear on the display section 4.
• Press the CHANNEL / + button to select the display section 4. The arrow appears
on the corresponding display section.
• Press the CHANNEL / + button to change between the installed transmitters.
• Press the button again after showing the last installed transmitter, on the display
appears the circle symbol. On the display section 4 appear in sequence, the values
of the internal sensor and the fourth to eighth transmitter. Press the button again
to deactivate the function.
• On the display appear again the measured internal values.

6.4 Temperature display

• Press and hold the MIN/MAX / – button in normal mode to change between °C
(Celsius) or °F (Fahrenheit) as temperature unit.
6.5 Display of the temperature tendency
• The trend pointer on the display indicates if the temperature values are increasing,
steady or decreasing.
6.6 Comfort level
• On the display appears a friendly face (RH 45...65%), a neutral face (RH
< 45%) or sad face (RH > 65%) to indicate the comfort level of the climate.
RH < 45% RH 45...65%
dry comfortable
RH > 65%
wet
21