instructions for the device.
2. Printing material
For the best results, use material that is clean, non-greasy, dry
and at the same temperature as the print head.
Polar or polarised surfaces are better suitable on plastics to be
printed on than surfaces with unpolar properties.
Before carrying out a large print job, perform a test print.
3. Storage Fig.
MP ink is fast-drying. The time it takes the print nozzles
to dry up depends on the ambient temperature
and the humidity.
Where the device is not equipped with a nozzle cover, protect
the printing cartridge
3
when interrupting work.
To securely close the nozzles
keep the seal at the dust cover
Remove the printing cartridge
f
Guide the printing cartridge into the dust cover
f
Push the printing cartridge back until the latching wing
f
clicks.
Use the print head within four weeks after opening.
7
+
A
B
2
against drying out with the dust cover
6
of the printing cartridge
3
2
free from dirt and dust.
out of the device.
6
2
,
3
.
4