Velleman CTC1000RC Mode D'emploi page 7

On the siren, LEDs 1 and 3 will flash once with a
beep to confirm.
2. On the remote, press the disarm button to exit
learn mode.
On the siren, LED 2 will flash once to confirm.
3. Press both arm + home arm buttons to disable
tamper protection.
The siren will beep once ton confirm.
4. Proceed to change the siren's batteries.
5. Press both arm + home arm buttons to enable
tamper protection. The siren will beep once to
confirm.
Low battery detection
The remote control has a low battery detection
system. The battery status will be sent to the control
panel along with regular signal transmission, and,
the control panel will display the battery status
accordingly.
WARNING
 Do not puncture or throw batteries in fire as
they might explode.
 Keep batteries away from children.
8. Technical Specifications
power supply
frequency
V. 01 – 12/06/2013
CTC1000RC
1 x lithium CR2032 battery
(incl.)
868.6375 MHz
7 ©Velleman nv