Safety Precautions - SKF 226400 Mode D'emploi

Read this instruction for use fully. Follow all safety precautions
to avoid personal injury or property damage during equipment
operation. SKF cannot be responsible for damage or injury
resulting from unsafe product use, lack of maintenance or incorrect
equipment operation. In case of any uncertainties as regards the
use of the equipment contact SKF.
Failure to comply with the following could cause equipment
damage and personal injury.
• Do ensure that the equipment is only operated by trained
personnel.
• Do wear proper personal protective gear, such as eye
protection and protective gloves, when operating the
equipment.
• Do inspect the equipment and all accessories carefully before use.
• Do not use damaged components or modify the equipment.
• Do use clean recommended hydraulic oils (SKF LHMF 300,
LHDF 900 or similar).
• Do not use glycerin or water based luids as a pressure
medium. Premature equipment wear or damage can result.
• Do not use the equipment above the stated maximum
hydraulic pressure.
• Do not extend the handle in order to reduce the required
force to reach maximum pressure. Use hand pressure only.
• Do not use the injector with accessories, which are rated
below the maximum working pressure of the injector.
• Do not use washers on sealing surfaces.
• Do use a pressure gauge to monitor the oil outlet pressure,
wherever possible.
• Do ensure that all the air has been removed from the
hydraulic system before pressurising the hydraulic system.
• Do prevent the workpiece (e.g. bearing, gearwheel or similar
item) from being forcibly ejected upon sudden release of
pressure (e.g. by use of retaining nut).
• Do not handle high pressure pipes. Oil under pressure can
penetrate the skin, causing serious injury. If oil is injected
under the skin, seek medical attention immediately.
• Do not use damaged high pressure pipes. Avoid sharp bends
and kinks when connecting pipes. Sharp bends and kinks
will internally damage the pipe leading to premature failure.
Applying pressure to a damaged pipe may cause it to rupture.
• Do not lift the equipment by the pipe or couplings.
• Do follow local safety regulations.
• Do service the equipment by a qualiied hydraulic technician
or SKF Repair Centre.
• Do replace worn or damaged parts with genuine SKF parts.
6
READ THIS FIRST

Safety precautions

SKF 226400