Sony SU-P42T1 Mode D'emploi page 6

Step 3: Install the Display Unit
WARNING
Be sure to complete the installation before connecting the Power Cord to the wall outlet. If you allow the Power
Cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock.
If you stumble over the Power Cord or the Display Interface Cable, the stand may topple over, and this may
result in injury.
1
Install the Display Unit on the Tabletop Stand.
1 Connect the Power Cord and the Display Interface cable to the Display Unit.
Tip
See the instruction manual of the Sony Flat
Panel Colour Television (KE-42MR1/KE-
50MR1) for more details on connecting the
Power Cord and the Display Interface Cable.
2 Be sure that two or more persons hold the right and left edges of the top and the under sides of the
Display Unit while fitting the hooks on the rear of the Display Unit into the holes on the fixtures of the
stand. Then confirm that the hooks on the rear of the Display Unit are completely inserted into the four
holes of the fixtures.
Note
Do not stumble over the Power Cord or the
Display Interface Cable.
6
(GB)
Soft rag such as a blanket
1
Rear side of the Display Unit
2
Rear side of the
Display Unit
For Sony Dealers
Power Cord
Display Interface
Cable