Lowara 001075038 Directives D'installation Et D'utilisation page 48

en en
en en
Parameter list of the Extended Menù Parameter list of the Extended Menù
Parameter list of the Extended Menù Parameter list of the Extended Menù
Rif. Rif. Rif. Rif. Parameter Parameter Parameter Parameter Model Model Model Model
MMA
00 Password
MMW
MMA
01 fnom. motor
MMW
MMA
02 Language
MMW
MMA
03 f (Umax)
MMW
MMA
04* Configuration
MMW
MMA
05 Input Buffer
MMW
MMA
06 Ramp 1 Acceler.
MMW
MMA
07 Ramp 2 Deceler.
MMW
MMA
08 JOG Frequency
MMW
MMA
09 Drive State
MMW
MMA
10
MMW
11 fmin /MotorStop MMA
12 Drive ResetTime MMA
48
Read Read Read Read
(R) (R)
(R) (R)
Unit Unit Unit Unit Min Min Min Min Max Max Max Max
Write Write Write Write
(RW) (RW) (RW) (RW)
RW Hz 39.99 99.99
RW
RW Hz 29.99 99.99
RW N. 0 2
R N. 0 255
RW sec 0.7 5
RW sec 0.7 5
RW Hz 0 Par.(1)
R 0 0 107
R 0 0 104
RW Hz 0 Par.(1)
RW sec 0.1 100
Defaul Defaul
Defaul Defaul
Description Description Description Description
t t t t
Password for changing parameters in the Extended Menu - for reading only no
00066
password is needed. If password was set wrong the message: "???password=0..." will
(0074
be displayed and values were not changed.
0)
45 Rated frequency of motor. This value f(nom) is indicated on the motor rating plate.
Italian Language selection.
50 Frequency applied to the motor to obtain Umax (e.g.: set 50 to obtain 230V at 50 Hz)
1 This parameter must be set to default value "1"
Varie Read digital inputs
Time required for the output frequency applied to the motor to pass from zero to
1.5
maximum frequency.
Time required for the output frequency applied to the motor to pass from maximum
1.5
frequency to zero.
Sets the frequency applied to the motor in the manual mode. In the operating mode
50
(para 28) it must =0
Coded number, used to display driver state information. Examples: 0=off, 1=motor
accelerating, 2=constant speed, 3=deceleration, 4=stopping, 5=stopped, 100=over
Varie current FF. 101=over current FT, 102=under voltage, 103=over voltage, 104=over
temperature, 105=Short circuit shut-down, 106=protected I2T, 107=motor
disconnected.
Coded number, used to display hydraulic system information and measurements.
Varie 0=Disabled, 1=Stop, 2=Run, 100=No water, 101=Insufficient pressure, 102=Pressure
sensor fault, 103=Water hammering.
Minimum permitted motor frequency. The driver shuts down below this value. Active if
10
different from 0.
10 Delay between one motor start and the next following a driver fault. Driver 10X states