SuperFish KOI PRO Combi Drum 30000 Mode D'emploi page 8

Replacing the screen panel
• In case of wear or damage, the screen panel should be replaced as soon as possible to ensure optimum filter
performance.
• Remove the plug(s) from the socket and close the water circuit.
• Remove the lid from the housing.
• Ensure that the water can flow out of the filter.
Fig. G Turn the drum by hand until the mounting strip (y) and both clamping straps (z) point upwards.
• Remove the mounting strip by unscrewing the screws and loosen the clamping straps.
• Remove the screen panel (x).
• Insert the new screen panel and reinstall the clamping straps and mounting strip correctly.
• Turn the drum by hand and verify that everything is fixed correctly.
• Place the lid back on the housing.
• Restore the water circuit and plug in again.
• Press and hold the push button (v) on the control box for 10 seconds so that the electro motor and spraying
system are activated again.
Protection of electro motor by means of friction clutch
• The drive shaft of the electro motor is protected by means of a friction clutch. If the drum becomes jammed, the
friction clutch is automatically activated to prevent the electric motor from burning out.
• Remove the plug(s) from the mains and remove the lid from the housing.
• First, investigate why the drum is blocked and make sure the drum can rotate freely again.
• Thereafter you can release the protection by retightening the locknut on the drive shaft with a torque spanner set
at 65 Nm.
• NOTICE! Never tighten the locknut with a normal spanner. If in doubt, always consult a qualified technician!
• Remove the cover of the electric motor (m).
• Set the torque spanner to a tightening torque of 65 Nm.
• Place the torque spanner on the M10 locknut. The locknut is located on the drive shaft at the back of the motor.
• Hold the drum with your hand and tighten the locknut with the torque spanner.
• Check that the friction clutch is deactivated. Turn the drum by hand and check that the drive shaft rotates with it.
• Place the cover back on the electro motor, the lid on the housing and plug(s) back into the mains.
Bypass of the drum filter
• The drum filter can be bypassed in case of a treatment or technical challenge.
• Switch off the control box and remove the lid from the housing.
• Remove the two red caps (r) from the wall between the front chamber and the drum section.
• Remove the plug of the pond pump from the control box and plug it directly into another socket.
• The water now flows through these holes into the second filter chamber.
• NOTICE! The control box is switched off, which means that the level protection no longer works either!
8