Bresser National Geographic 9118300 Mode D'emploi page 25

EN


d
E
d
Fig. 3b
Fig. 3a
Viewfinder / LED viewfinder
Depending on the telescope model you have, screw your viewfinder or LED viewfinder to the holder (Fig.
3a) or insert it directly (Fig. 3b). Then affix the viewfinder with screws. Check carefully which step is right
for your viewfinder.
How to insert an eyepiece if you use a refractor telescope:
Take the lens cap off the eyepiece (6). You can now place the zenith mirror (16) into the eyepiece holder
and secure it with the small screw on the connector (Fig. 4). Next, set the eyepiece (15) into the opening
of the zenith mirror (16) (Fig. 4). Here too, there is a screw with which you can screw the eyepiece onto the
zenith mirror.
Note: First, put the eyepiece with the largest focal width (e.g. 20 mm) onto the zenith mirror. While you'll get
the least amount of magnification, it will be easier for you to view things.
25