Operating Homelink - Toyota HomeLink Mode D'emploi

Operating HomeLink

The vehicle should be within the operating
range of the gate or garage door opener. The
HomeLink system operates the gate or garage
door opener (or another device) in exactly the
same way as the original remote control.
When you have programmed the HomeLink
system, press the appropriate button I, II, or
III on the control panel to activate the gate or
garage door opener (fig. 4).
®
The diode will light up when you press the
button on the control panel.
For convenience, the original remote control
of the device may also be used at any time.
In the case of a standard code, the HomeLink
diode is constantly illuminated throughout the
transmission process. For use with compatible
systems, no further action is necessary.
If HomeLink does not operate your system, this
may be because your original remote control
has a rolling code feature. With a rolling code
system, the HomeLink diode flashes quickly for
a short time and then stays on constantly for
two seconds. This pattern repeats itself for up
to 20 seconds. You will find advice about this
fig.4
in the section on Rolling Code Synchronisation.
NOTE:
Do not press the button more than
20 seconds, or it will enter the programming
mode.
EN
HomeLink 7