Baninni Room Série Mode D'emploi page 15

4) FOLDING THE TRAVEL COT
1.Undo the velcro straps, remove and set aside the floorbaord and the cover sheet. Grab the
center of the floor support loop and rise approximately twelve inches with a slight jacking
action. (Fig.17)
2. Push the button, which are located at the exterior sides of the center of the four top rails.
(Fig.18)
3. Gather the playard frame together as you pull up on the center floor loop. (Fig.19) Make
sure when compacting the frame that the two shorter 'V'shaped rails (D) are pointing slightly
inwards and the longer 'V'shaped rails are pointed slightly outwards (E).
(Fig.20)
Note:
The above step must be done properly for the playard to fit in the travel bag.
4.Wrap the floorboard around the playard frame with the sheet and
soft side next to the playard frame (Fig.21)
5. Secure the velcro straps throught the loops on the end floorboard.
(Fig.22)
6. Put the carring bag over the playard as started, so the carrying han-
dle comes through the opening. (Fig.23 and Fig.17)