Important - Baninni Room Série Mode D'emploi

1) INSTALL THE TRAVEL COT
1.Unzip the travel bag and remove contents, stand up playard assembly so the floor loop (A) is
on top and the feet (B) are on the bottom. (Fig1)
2. Undo the three velcro straps (C) that secure the playyard frame. (fig2) put the floorboard
aside.
3. Seperate the legs to be approximately two feet apart. (Fig.3)
4. Keep the center being up about half of the legs height. Expand the two shorter top rails by
holding the rail locks and pulling upward to make sure the top rials been locked and straight
up competely. (Fig.4)
5. Then same way for the two longer top rails. (Fig.5)
6. After all the four top rails been locked and straight up completely, push down on the center
of the playard floor until it locks into a flat position. (Fig.6)
C
MATTI - BNBT018
IMPORTANT: retain for future reference
read carefully!
Note:
A) Please double check if all four top rails been locked completely to avoid
danger.
B) Rail locks are located in the center of the top rails and are completely inclosed
within the top fabric.
GB