Baninni Room Série Mode D'emploi page 13

7. Place the footbaord in the playard. (Fig.7)
8. Secure the floorboard to the playard frame by passing
the four velcro straps (Fig.8) through the four holes in
the bottom of the playard (Fig.9) and securing the velcro.
(Fig.10)
Your playard is now ready for use.
2) INSTALL THE SECOND LAYER
1. Set up the playard using hanging hooks to tighten the rails around. Smooth the fabric for the
second layer support. (Fig.11)
2. Put the short iron pipes into the holes at the bottom of the second layer support. Join corre-
sponding ones togheter to open the crib fulle. (Fig.12)
3. Unfold the mattress, put it into the playard. Make sure it has been laid on the right
position. (Fig.13)
Your second layer support is now ready to use.
Caution:
1. Do not use the second layer support when the crib has not been fully opened to fixed position.
2. For baby's with a Max. weight of 9kg and Max. height of 75cm.
3. As your baby has been able to climb, please stop using the second layer support immediately.
4. Do not leave your baby alone in the crib without adult supervision.