H.Koenig V6 Manuel D'utilisation page 9

continue happen for more than 60 seconds, please check whether water tank and filter
assembled correctly or not
When set selection button at "NYLON" position, no steam escaped since it only just suits for
a.
dry ironing.
When set fabric setting at "POLYESTER" / "RAYON" / "COTION"
b.
"LINEN" ,steam willautomatically vary according to sole-plate temperature. Pump will stop
working and no steam escaped when sole-plate temperature decrease too low.lt will
resume after reheated to desiredtemperature.
Dry ironing
Connect the appliance to a suitable socket outlet, lay handle down. Power indicator light
1.
(red} "<!) "on iron unit light up ,it indicates that the unit has been connected to power
supply.
Set selection button to desired position according to above fabric setting chart. Blue
2.
indicator light at iron unit blinks slowly to indicate the unit being heated up. When the blue
indicator light change to light up steadily and an audible "Bi" signal produced, the desired
temperature has been reached. During use, blue indicator light will cycle from blinking to
light on steadily, and then from steady mode to On. lt does not indicate a defects or hazard,
it is just because the appliance are temperature constant.
After use, put iron unit back onto the base unit again, turn selection button to" <!)
3.
",and then unplug the appliance from main socket .
Note: When changing your Temp setting from higher setting to lower, it is proposed that
not to start ironing immediately since it may cause burns to your fabrics. Please wait till blue
indicator light lights up steadily, and then start ironing.
Vertical steam ironing
Follow the steam ironing process, and then hold the iron in vertical position between 5cm and
15cm away from the hanged fabrics. Press down steam switch, this will create vertical steam.
This feature is especially used for removing creases from hanging clothes and curtains. Never
directly perform steam ironing on
Auto shut off function
The appliance willcorne intoauto shut off modealong with audible "Bi..." signal when ithas been used for
60 minutes continuously with temperatureset atany settings, power indicator light" c!)"Blink. Press
selection button to reset another 60 minutes cycle if continuous use is necessary.(Note:once each setting
is pressed,the unit will reset time)
people.