Rearpanel; Input Jack; Cleaning And Maintenance - Omnitronic CL-66 Mode D'emploi

14. GAIN REDUCTION (-30 dB to -1 dB)
It indicates the compressed dB quantity.
15. GATE LED
This LED lights up when NOISE GATE is on processing and thus no signal comes in. The LED turns off
when there is signal passing through.
16.POWER ON/OFF SWITCH

4.2 Rearpanel

17.IN/OUT level (+4 dB, -10 dB)
It adjusts the signal level of the preamplifier to match with the CL66. The switch shifting changes the way the
input/output meter references signals.
18. DC JACK (Power AC 10V)
This emit needs an AC10V/600mA power supplied by OMNITRONIC. Use of any other AC adaptor voids the
warranty.

19.INPUT JACK

This is the input connector to take signals from any low line level signals such as mixing console, tape
recorder or synthesizer and other unbalanced signal sources etc. to be limited, compressed or gated.
20. OUTPUT
This provides processed ouput.
21. SIDE CHAIN
This is special connector and allows you to control this CL-66 by other devices. For example, by using a
send/return cable you can send the signal out to another device such as an EQ to reproduce the signal and
then return it back for better sound quality. Boost the high frequency, the vocal sibilance is removed by
differential compression. If low frequency EQ cut is used, the compressor allows drum sounds to get through
more or less unaltered yet may clamp down on a less powerful big synthesizer note.

5. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free cloth moistened with any good
cleaning fluid. Never use alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
16/23 10360501X59NXS_V_1_0.DOC