Omnitronic CL-66 Mode D'emploi page 15

8.A)Filter On/Off Switch 8.B) Filter setting (35Hz-4kHz)
When Filter On/Off switch is pushed down at allows passes of some signal depending its setting position.
For example, if the FILTER ON/OFF switch is a "ON" position and the filter setting control positions at 35Hz
its allows signal between 30Hz to 40Hz to pass through.
MASTER AREA
9. PEAK RMS
In peak mode the ATTACK/RELEASE controls in Compressor-Limiter area decides the compression start
and release interval. In RMS mode it is pre-factory set.
10.Hard-Knee, Soft-Knee
In conjunction with ATTACK/RELEASE time control the hard-knee creates a harsh compressed signal, while
the soft-knee creates a smooth compressed signal. FIGURE D thereunder illustrates signals created by hard
knee and soft knee and the influences of ATTACK and RELEASE time setting to the signal curve.
11. Stereo-Link Dual-Link
At Stereo link CH A controls both channels. At Dual mono link CH-A and CHB works independently.
12. Bypass-Comp
At Bypass mode the in/out signal sends out directly and is unaffected by the controls settings. Input signal is
equal to the output signal. At COMP mode, all input signals are affected by this machines factory presetting.
This gives an easy and quick comparison between uncompressed and processed signals.
13. IN/OUT LED display (-25 to +4 dB) and control switch
When the in/out switch is at "IN" position the LED display indicates the INPUT level. When the switch is in
"OUT" position, it indicates the OUTPUT level.
15/23 10360501X59NXS_V_1_0.DOC