General Operating Indications; Adjusting The Cup/Espresso Cup Height - Caffitaly System S24 Mode D'emploi

DESCALING SIGNAL:
• When warning light D blinks YELLOW and the machine beeps 3 times, a descaling cycle
should be carried out (see ch. Descaling).
HEATING:
• Buttons A-B-C blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
• The water tank is empty when warning light D blinks RED and the appliance emits 3
beeps followed by a single intermittent beep.
• Fill the water tank with fresh, still water (Fig. 4).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water.
• When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• Warning light D blinks RED. The appliance will immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons A-B-C to reset the alarm.
• The appliance is ready for use again.

Adjusting the cup/espresso cup height

• The machine can be adjusted for the use of large cups or espresso cups.
• The machine is initially set for the use of large cups (Fig. 7).
• To achieve the best results when using espresso cups, you must lift and turn the grid on
top of the drip tray (Fig. 10).
• An espresso cup can now be placed under the coffee dispenser (Fig. 8)

General operating indications

19