Package Contents - Zotac ZBOX Guide D'installation Rapide

Package contents

• 1 x ZOTAC ZBOX
• 1 x Stand
• 1 x VESA mount
• 1 x AC Adapter
• 1 x Power Cord
• 1 x Warranty Card
• 1 x User Manual
• 1 x Driver disc
• 1 x DVI-to-VGA adapter (optional)
• 2 x antennas
• 1 x Remote Control (optional)
• 1 x USB External IR Receiver (optional)
Customizing your ZOTAC ZBOX
1. Lay the ZOTAC ZBOX on a flat surface
with the rubber feet facing upwards.
2. Locate the two thumb screws and remove.
3. Slide the cover off the ZOTAC ZBOX in
the direction of the arrow.
Installing memory modules
1. Locate the SO-DIMM memory slots and insert a
SO-DIMM memory module into the slot at a 45 degree
angle.
(Note: If the ZOTAC ZBOX has two SO-DIMM slots insert a
module into the lower slot first)
2. Gently press down on the memory module until it locks
into place by the arms of the memory slot.
Installing a hard disk
1. Locate the 2.5-inch SATA hard disk and the
hard disk bracket.
2. Install the hard disk to the hard disk bracket.
3. Insert the hard disk into the slot at a 45 degree
angle and gently slide into the connector.
4. Reinstall the thumb screw.
2
1
2
1
1
3
3
2
2
4