Safety Inspection; Single Safety Inspection Before Commissioning - Nussbaum JUMBO LIFT 3200 NT Manuel D'exploitation

15

Safety inspection

15.1 Single safety inspection before commissioning

Copy, complete and leave in the inspection book
i
Test step
Model plate ___________________________________
Operating manual _____________________________
Load capacity details on the system ___________
Main switch function ___________________________
Function button "LIFT, LOWER" __________________
General system condition ______________________
Condition / function of foot bumper (optional) __
Condition/ function ramps / rollers ______________
Securing the bolts _____________________________
Condition of bolts and bearing seating _________
Load bearing construction (deformations, cracks) _______ _______
Unit condition _________________________________
Cover conditions _____________________________
Paint condition ________________________________
Condition piston rods and wipers _______________
Hydraulic system leak-tightness _________________
Hydraulic oil filling level ________________________
Hydraulic line conditions _______________________
Condition hydraulic screw fittings _______________
Condition electrical lines _______________________
Condition of weld seams ______________________
Fastening anchor torque ______________________
Fastening screw torque _______________________
Condition of polymer overlays __________________
Condition of concrete floor (cracks) ____________
Function CE stop and warning signal (optional) _
Function balance of rails _______________________
Functional test, system with load _______________
*) Place a checkmark in the relevant, if a retest is required then check it again!
Safety inspection done on: ___________________________________________________________
Performed by company: _____________________________________________________________
Name, address of specialist: _________________________________________________________
Result of inspection:
______________________________
Signature of specialist
If requested to take care of deficiencies
Deficiency removed on: _________________________________
(use a new form for reinspection!)
20110009 OPI Version 1.0
OK
Continued operation questionable, reinspection required
Continued operation possible, remove defects by ___________________
No deficiencies, continue to operate
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH
Serial number: _________________________________
Defective Retest
or Missing
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
_______ _______ ______________________________
______________________________
Operating company signature
______________________________
Operating company signature
Remarks
77