Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-1156-001.book Page 37 Thursday, February 11, 2010 12:08 PM
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer
Horizontal mitre
corner
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Bosch Power Tools
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Placed
against
the fence
0°
Left side
Right side
45° left
45° right
Bottom edge
Bottom edge
on saw table
on saw table
... to the left of
... to the right
the cut
of the cut
45° right
45° left
Bottom edge
Bottom edge
on saw table
on saw table
... to the right
... to the left of
of the cut
the cut
English | 37
Lying flat
on the
saw table
45°
Left side
Right side
0°
0°
Upper edge
Bottom edge
against the
against the
fence
fence
... to the left of
... to the left of
the cut
the cut
0°
0°
Bottom edge
Upper edge
against the
against the
fence
fence
... to the right
... to the right
of the cut
of the cut
1 609 929 W04 | (11/2/10)
Publicité
Table des Matières
