Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical connection
Connect the sensors with the terminals. The sensors must be supplied
via an external PELV or NON PELV voltage source.
All outputs (relays) must be supplied with the same voltage (e.g. 2 x
240 V AC or 2 x 24 V DC).
Connection
A+:
AS-i +
A-:
AS-i -
I+:
sensor supply +24 V
I-:
sensor supply 0 V
E+:
external sensor supply +24 V
E-:
external sensor supply 0 V
I1 ... I4: switching inputs sensors 1 ... 4
LEDs 1: switching status indication
inputs
LEDs 2: AS-i, FAULT, AUX
LEDs 3: switching status indication
actuator outputs
ADR:
addressing socket
Operation
Check the safe functioning of the unit. Display by LEDs:
• LED green: voltage supply via the AS-i network O.K. or external
power supply o.k.
• LED yellow: input/output switched
• LED red is lit: AS-i communication error, e. g. slave address 0
• LED red flashing: peripheral fault, e.g. no auxiliary voltage
Technical data
You can download the data sheet from the Internet if required
(www.ifm.com).
LEDs 1
LEDs 2
ADR
LEDs 3
O1
O2
12 14
22 24
11
I- I- E+
E-
I1 I2 I3 I4
I+ I+ I+ I+
14 11 11 12
24 21 21 22
A+ A-
21
7
Publicité
Table des Matières
