13.1.
CLEANING OF THE FLUE
A correct lighting, the burning of a proper fuel, the loading of the suggested quantity of fuel, the right adjustments of
the secondary air control, the sufficient draught of the chimney and the presence of air for the combustion, are
essential for the good operation of the appliance.
The appliance should be completely cleaned at least once a year or every
time it is needed (in case of bad
working and low yield).
The cleaning must be carried out exclusively with cold equipment.
This operation should be carried out by a chimney sweeper who can
simultaneously perform an audit of the flue (checking of possible
deposits). During cleaning, remove from the cooker the smokes exhaust
small trunk and the smokes pipe.
The smokes collection casing can be cleaned either through the door
which is under the oven (after removing the two screws which fix the door
to the front side of the cooker Picture 8, please verify that the deflectors
are set as indicated in the Picture 9) or from the top.
To this purpose remove the circles of the cooking plate and disassemble
the smokes pipe from the exhaust small trunk.
Cleaning can be made with a brush and a vacuum cleaner.
Pay attention that, after cleaning, all dismounted parts are
reinstalled hermetically.
13.2.
CLEANING OF THE GLASS
Thanks to a specific entry of the secondary air the building of deposit on
the glass of the door is slowed down in a remarkable way. However the
building of this deposit cannot be avoided with the use of solid fuels such
as wet wood, and this is not to be considered as a defect of the
appliance.
IMPORTANT: The cleaning of the sight glass must be carried out
only and exclusively with cold appliance to avoid the
explosion of the same. Do not use cloths, abrasive or
chemically aggressive products by cleaning the hearth
glass.
The correct lighting phase, the use of proper quantities and types of fuels,
the correct position of the secondary air regulator, enough draught of the
chimney-flue and the presence of combustion air are the essential
elements for the optimal functioning of the appliance and for the cleaning of the glass.
BREAK OF GLASSES: Considering that the glasses are manufactured in glass-ceramic and resistant to heat
shock up to 750 ° C, they are not subject to thermal shocks. Their break can be caused only by mechanic
shocks (bumps or violent closure of the door, etc.). Therefore, their replacement is not included in the
warranty.
13.3.
CLEANING OF THE ASH DRAWER
All the appliances are equipped with a shaking hearth grate and an ash drawer for the collection of the ashes.
It is suggested to empty periodically the ash drawer and to avoid it fills completely in order not to overheat the grate.
Moreover, we recommend leaving always 3-4 cm of ash in the hearth.
ATTENTION: The ashes removed from the hearth have to be stored in a container made of fire-resistant material
equipped with an air-tight cover.
The container has to be placed on a fire-resistant floor, far from flammable materials up to the switching off and
complete cooling.
13.1.
VARNISHED PRODUCTS
After some years of product use a change in the varnished details colour is totally normal. This is due to the
considerable temperature range the product is subject to whenever in use and to the varnish ageing of time passing
by. ATTENTION: before any possible application of the new varnish, do clean and remove all the traces from the
surface which has to be varnished.
13.2.
ENAMELLED PRODUCTS
For the cleaning of enamelled surfaces use soap water or not aggressive and not chemically abrasive detergents.
After the cleaning do NOT let soapy water or any cleanser dry but remove them immediately.
13.3.
CHROMIUM-COMPONENTS
If the components become bluish due to overheating, this can be solved with a suitable product for cleaning. DO NOT
use abrasives or solvents.
24
ROSA - ROSETTA
Picture 8
130-150mm
Picture 9
1095080
– EN