Important Remarks - Velleman VTSSC40N Mode D'emploi

Do not inhale solder fumes. The vapours that are released during
soldering are harmful. Therefore, you shall only use the soldering
station in well-ventilated areas or under an exhaust hood (solder
fume extractor). Dispose of fume filters and solder residue in
accordance with local regulations.
• Use the soldering iron on a heatproof workbench.
• Place the soldering iron in its holder after use.
• Let a hot soldering iron cool down naturally and do not immerse in water.
3. Operating Instructions
1. Verify whether the mains voltage is compatible with the operating voltage of the device before plugging
it in.
2. Make sure that the device was not damaged in transit.
3. Connect the soldering iron by means of the 4-pin plug and screw its nut tightly.
4. Switch the device on by means of the on/off switch and set the desired temperature by means of the
pushbuttons. One brief push will result in a 1° modification; keep the button pushed to modify faster (steps
of 10°).
The set temperature is stored internally: the next time you use your VTSSC40N, it will automatically display
the last set temperature.
4. Tips for New Tips
1. Switch the device on and set a temperature of 250°C.
2. Coat the surface with solder when the temperature of the tip has reached 250°C.
3. Install the desired temperature after allowing the unit to idle at 250°C for 3 minutes.
The iron will be ready for use when the preset temperature is reached.
5. Common Causes for Tip Failure
•
The tip is not sufficiently tinned.
•
Wiping the tip on a surface with high sulphur content or on a dirty or dry sponge or rag.
•
Contact between the tip and organic or chemical substances such as plastic, silicone, grease, etc.
•
Impurities in the solder and/or solder with a low tin content.
6.

Important Remarks

•
Remove and clean the tip after heavy or moderate use. We recommend cleaning the tip every day if the
device is used on a daily basis. Clear the tip from excess solder. Never clean the tip with a file or other
abrasive materials.
•
Always tin the tip before returning it to the holder, prior to deactivating the station or in case of long
periods of inactivity. Clean the tip with a wet sponge or with our tip cleaner (ref. VTSTC) prior to use.
•
Do not use temperatures > 400°C for long periods of time as this will shorten the life of your tip.
•
Do not heat the soldering iron without a tip: this will damage the heating component and the temperature
sensor.
•
Do not press too hard on the tip while soldering: this does not improve the heat transfer and may damage
the tip.
•
Only replace a blown fuse when the device is powered down and disconnected from the mains.
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulted from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 06 – 16/12/2020
VTSSC40N
4 ©Velleman nv