Velleman VTSSC40N Mode D'emploi page 3

VTSSC40N
Indoor use only. Keep this device away from rain, moisture,
splashing and dripping liquids. Never put objects filled with liquids
on top of or close to the device.
Always disconnect mains power when the device is not in use or
when servicing or maintenance activities are performed. Handle
the power cord by the plug only.
Caution! After switching off, leave the power cord plugged in
for a few minutes. When you switch off the unit, the automatic
cooling function blows cooling air through the heater pipe for a
short period. This protects the heater from damage and extends
its lifetime. Do not disconnect the mains plug during this cooling
process.
Do not crimp the power cord and protect it against damage.
Warning! If the power cord is damaged, it must be replaced by
the manufacturer, its service agent, or similarly qualified persons
in order to avoid any hazard.
Make sure that the available voltage does not exceed the voltage
stated in the specifications of this manual.
Plug the power cord into a suitable, earthed mains outlet.
Risk of electroshock when opening the cover. Touching live
wires can cause life-threatening electroshocks. Do not
disassemble or open the housing yourself. Have the device
repaired by qualified personnel.
Do not operate the device with wet hands.
Never use the device on live electronic circuits. Make sure power
to the work piece is cut and capacitors are discharged.
Do not use near inflammable products or in explosive
atmospheres. Heat can cause fire to inflammable products even
when they are not in sight. Only use in properly ventilated rooms.
Incorrect use may cause fire.
Do not touch the shafts, tips, or hot air gun as this can cause
serious burns. Keep the tips and hot air away from the body,
clothes, or other flammable material. Do not aim the hot air gun
at the eyes. Use gloves and/or heat-resistant tools to pick up the
PCB assembly to prevent burns. Always return the irons and gun
to their stands between uses; always let the device cool down
after use and before storage.
Place the device on a level, stable, and fire resistant working
surface.
WARNING! - This tool must be placed on its stand when not in
use; do not leave the tool unattended when switched on.
V. 06 – 16/12/2020
3 ©Velleman nv