Simu T5ZSP Notice Originale page 6

EN-
S.A.S. au capital de 5 000 000 € - Z.I. Les Giranaux - BP71 - 70103 ARC-LÈS-GRAY CEDEX - FRANCE - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
These instructions apply to all T5ZSP drives, the different versions of which are available in the
current catalogue.
Field: The T5ZSP drives are designed to drive all types of exterior vertical blinds excepted latching
system. The installer, who must be a motorisation and home automation professional, must ensure
that the drive product is installed in accordance with the standards in force in the country in which it is
installed such as EN 13561 relating to outdoor screens and awnings.
Liability: Before installing and using the drive, please read operating and installation guide carefully.
Please read these instructions carefully before installing and using the drive. In addition to following the
instructions given in this guide, the instructions detailed in the attached Safety instructions document must
also be observed. The drive must be installed by a motorisation and home automation professional, according
to instructions from SIMU and the regulations applicable in the country in which it is commissioned. It is
prohibited to use the drive outside the field of application described above. Such use, and any failure to
comply with the instructions given in this guide and in the attached Safety instructions document, absolves
SIMU of any liability and invalidates the warranty. The installer must inform its customers of the operating and
maintenance conditions for the drive and must provide them with the instructions for use and maintenance, and
the attached Safety instructions document, after installing the drive. Any After-Sales Service operation on
the drive must be performed by a motorisation and home automation professional. If in doubt when installing
the drive, or to obtain additional information, contact a SIMU adviser or go to the website www.simu.com.
INSTALLATION
1
Instructions which must be followed by the drive and home automation professional installing the
drive:
- All wiring must be conform to the national standards or IEC 60364 standard.
- Cables routed through metal must be protected and insulated by using grommets or bushings.
- The cable for the motor is replaceable. If it is damaged, replace with the same cable. The cable may only be
installed on the motor by a qualified personel. Care must be taken when replacing the cable not to damage
the contacts. Continuity of the earth (ground) connection must be confirmed.
Drilling of the tube:
*35 Nm max
Assembly :
1
0.55 Nm
±0.1
EN
1/5
T5ZSP
(230V ~ 50Hz)
IP44
ALUMINIUM WHEEL
9910004
STEEL
5
9910004
2
3
06/32 • 10/32 • 06/17
• 10/17 • 15/17
15/32
25/17 • 35/17
Ø4,8x10
Ø5 x 10
4
25Nm max.
5141248A
EN- ORIGINAL INSTRUCTIONS
i
A ØB C
Ø min.
583
47 5 26 4.2
653
657
-20°C / +60°C
mm
D L1 L2
596 619
666 689
670 693