Transporting; Environmental Protection; Maintenance And Assistance - Stiga 100 COMBI 3 Manuel D'utilisation

EN
• If the machine has no mechanical stoppers for
transport, accessories must always be resting
on the ground when the machine is parked,
stored or left unattended.
• Store the machine where children cannot get
to it.
Never store the equipment with fuel
in the tank inside a building where fu-
mes may reach a flame or a spark or a
source of extreme heat.
• Allow the engine to cool before storing in an
enclosed space.
• To reduce the fire hazard, keep the engine,
exhaust silencer, battery compartment and fuel
storage area free of grass, leaves, or excessive
grease.
• To reduce the risk of fire, regularly check the
machine for oil and/or fuel leaks.
• If the fuel tank has to be drained, this should be
done outdoors and when the engine is cool.
• The ignition key must never be left inserted in
the machine, or where children or persons not
familiar to the machine may reach it. Before any
maintenance or repair, remove the ignition key.
CAUTION! – Battery acid is corrosive.
In the event of mechanical damage or
overcharging, acid may leak out. Avoid
inhalation or contact with any part of
the body.
Inhaled acid fumes are harmful to mu-
cous membranes and other internal
organs. Seek medical attention imme-
diately.
CAUTION! – Do not overcharge the bat-
tery. Excessive charging may cause the
battery to explode with subsequent
acid leaks.
CAUTION! – Acid can seriously damage
tools, clothing and other materials. Rin-
se away spilled acid immediately with
water.
Do not short circuit the battery termi-
nals. Sparks occur which can result in
fire.
TAKE CARE over the hydraulic compo-
nents. Pressurized hydraulic fluid leaks
may lead to injection injuries which can
8
ENGLISH
(Translation of the Original Instructions)
seriously damage tissues and need im-
mediate medical attention.
3.5

TRANSPORTING

CAUTION! - If the machine is transpor-
ted on a truck or trailer, use ramps with
suitable resistance, width and length.
Load the machine with the engine
switched off, without a driver and
pushed by an adequate number of pe-
ople.
During
stopcock (if fitted), lower the cutting
deck assy or the accessory, engage the
parking brake and fasten the machine
securely with ropes or chains to the
hauling device.
3.6

ENVIRONMENTAL PROTECTION

• Safeguarding the environment must be a
relevant and priority aspect of machine use, of
benefit to the community and the environment
we live in. Avoid being a disturbance to the
neighbourhood.
• Adhere strictly to the local regulations governing
the disposal of packaging, oil, fuel, filters,
damaged parts or any other element which may
have an impact on the environment; this waste
should not be disposed of along with standard
household waste, but must be disposed of
separately and sent to special waste disposal
facilities for handling and recycling.
• Adhere strictly to local regulations governing the
disposal of cuttings.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.
3.7

MAINTENANCE AND ASSISTANCE

Before proceeding to hook-up/unhook the cutting-
means assembly to/from the machine, perform
washing procedures or maintenance in general:
Take the machine onto a flat surface.
Activate the parking brake (please refer
to the machine's manual)
transport, close the fuel