Lubrication; Replacement Of The Cutting-Means Assembly; Wear Protection Guard; Spare Parts - Stiga 100 COMBI 3 Manuel D'utilisation

EN
8.5

LUBRICATION

All lubrication points indicated in the table below
must be lubricated every 50 service hours and
after every wash.
Object Action
Wheel 2 grease nipples.
shaft
Use a grease gun filled with
universal grease.
8.6 REPLACEMENT OF THE CUTTING-ME-
ANS ASSEMBLY (21:A)
Wear protective gloves.
Check that the cutting-means assembly is always
perfectly sharpened.
This is essential for obtaining optimum results.
Always check the cutting-means assembly after
an impact.
To sharpen cutting-means assembly
contact an authorized technical assi-
stance service.
Damaged
must always be replaced.
Use genuine spare parts only.
Non-genuine spare parts, even those
which can be installed on the machine,
may cause injury or damage the machi-
ne.
Replace the cutting-means assembly when its
edges are worn.
Fit the new cutting-means assembly (21:A) wit the
marking (21:B) pointing downwards.
Tightening torque: 45 Nm.
8.7

WEAR PROTECTION GUARD

The lower side of the cutting-means assembly is
fitted with two wear protection guards. (22:A).
When the protection guards are worn proceed as
follows:
• Slacken and remove the screws (22:B).
• Remove the protection (22:A) and fit a new one.
• Screw in and tighten the screws (22:B).
14
cutting-means assembly
ENGLISH
Genuine spare parts and attachments have been
designed specifically for machines.
Non-original parts and attachments are not
Fig.
approved.
20A
Use genuine spare parts only.
Non-genuine spare parts, even those
which can be installed on the machine,
may cause injury or damage the machi-
ne.
The manufacturer shall decline all liabi-
lity in the event of injuries or damages
caused by non-genuine spare parts or
accessories.

10 TERMS OF PURCHASE

The warranty covers all material and manufactu-
ring defects.
The user must follow all the instructions provided
in the accompanying documentation.
The warranty does not cover damages caused by:
• failure to become familiar with the
documentation accompanying the machine,
• carelessness,
• incorrect or prohibited use or assembly,
• use of non-genuine spare parts,
• use of accessories not supplied or approved.
The warranty does not cover:
• normal wear and tear of consumables, such as
drive belts, headlights, wheels, bolts and wires.
• normal wear and tear.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged by
the national laws in his own country are not in any
way restricted by this warranty.
(Translation of the Original Instructions)

9 SPARE PARTS