Control Panel - Panasonic EY45A5 Instructions D'utilisation

Control Panel

(L) Battery low warning lamp
Off Flashing
(normal (No charge)
operation) Battery protection
feature active
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically.
The tool includes a battery protection
feature designed to prevent excessive
discharging of the battery pack.
• The battery protection feature activates
immediately before the battery loses its
charge, causing the battery low warning
lamp to flash.
• If you notice the battery low warning
lamp flashing, charge the battery pack
immediately.
• If it is started with too little battery power
remaining, the tool may stop operating
without the battery low warning lamp
flashing first. This indicates that there is
too little battery power remaining to use
the tool, and the battery pack should be
charged before further use.
• If the tool is subject to a sudden load
during use that causes the motor to lock
up, the over-discharge prevention sensor
may be triggered, and the battery low
warning lamp may flash.
The lamp will stop flashing once you
address the cause of the motor's locking
up and cycle the trigger.
( L ) ( M )
CAUTION:
The over-discharge protection function
works even when both the battery low
warning lamp and LED light are flashing.
• Charge the battery pack immediately as
the battery power is getting low.
• When charging a cool battery pack
(below 0 °C (32 °F)) in a warm place,
leave the battery pack at the place and
wait for more than one hour to warm up
the battery to the level of the ambient
temperature.
• Weaken and cut off the power applied as
the voltage of the battery is plummeting
due to the high load acting on the motor.
Do not carry out operations that will
repeatedly cause the over-discharge
prevention function to be activated.
- 17 -
EN