Attaching Or Removing Battery Pack - Panasonic EY45A5 Instructions D'utilisation

WARNING
EN
Inserting a saw blade
If the saw blade is not mounted correctly
the blade may sit at an angle and will not
cut straight, causing motor burnout or
blade damage.
• Be sure to push until the back of the
saw blade contacts with the rear
bearings of the saw blade restraining
bearings (both). [Fig.4]
• Be sure that the saw blade is parallel to
the guide plate. [Fig.5]
4. Hand the saw blade on the saw blade
rotation roller, while holding the saw
blade so it does not fall off. [Fig.6]
5. Rotate the saw blade tension lever 180
degrees anticlockwise (direction of the
arrow), to tighten the saw blade. [Fig.7]
WARNING
Be careful not to trap your fingers in the
saw blade tension lever when selecting
the tension.
6. Move the saw blade in the direction of
rotation manually, and check whether it
hangs correctly on the saw blade
rotation roller (the saw blade should not
move outside the thickness of the saw
blade rotation roller).
NOTE:
If it is not hanging correctly, rotate the
saw blade tension lever 180 degrees
clockwise to loosen the saw blade and
rehang the saw blade.
7. Attach the saw blade cover and tighten
the saw blade cover fixing screw.
NOTE:
Tighten the saw blade cover fixing
screw while holding the saw blade
cover in position so it does not rise up.
Attaching or Removing
Battery Pack
CAUTION:
Before inserting battery pack, check that
the power switch in the tool actuates
properly and returns to the "OFF" position
when released.
1. To connect the battery pack [Fig.8]
Align the highlighted marker points and
attach battery pack.
• Slide the battery pack until it locks into
position.
2. To remove the battery pack [Fig.9]
Push down the button and slide the
battery pack forward.
- 14 -