Panasonic EY45A5 Instructions D'utilisation page 13

Symbol
Symbol
WARNING
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of the recycled battery pack and the
counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks,
dismantle it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack in
the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
Meaning
Volts
Direct current
No load speed
Revolutions or
reciprocations
Amperes
To reduce the risk of
injury, user must read
and understand
instruction manual.
For indoor use only.
WARNING
• When the Battery Pack Has
Deteriorated, Replace It with a New
One.
Continued use of a damaged battery
pack may result in heat generation,
ignition or battery rupture.
III. ASSEMBLY
Fitting a saw blade
CAUTION:
• Wear gloves when exchanging the saw
blade.
• Immediately after operation the saw
blade will be hot. Remove only after it
has cooled down.
• When attaching or removing a saw blade
or preparing, inspecting or storing the
device, be sure to remove the battery
pack first. Failure to do this could lead to
unintended operation and injury.
1. Loosen the saw blade cover fixing
screw and remove the saw blade cover.
[Fig.1]
• The saw blade cover separates into
two.
2. Rotate the saw blade tension lever 180
degrees clockwise (direction of the
arrow), to release tension. [Fig.2]
• Firmly set the saw blade tension lever
to maintain the saw blade tension.
3. Insert the saw blade into the saw blade
restraining bearings from the rear.
[Fig.3]
• Be sure to push it home until the back
of the blade contacts with the inside of
the saw blade restraining bearings.
- 13 -
EN