Philips S5000 Série Mode D'emploi page 35

Problem
I replaced
the shaving
heads, but the
replacement
reminder symbol
is still showing.
A shaving
head symbol
has suddenly
appeared on the
display.
The nose
trimmer
attachment pulls
at the hairs.
The nose
trimmer
attachment does
not work.
Possible cause
You have not reset
the shaver.
This symbol is
a replacement
reminder.
You move the
appliance too fast.
The cutting element
of the attachment
is very dirty, for
instance because
some nasal mucus
has dried inside the
cutting element.
ENGLISH
Solution
Reset the shaver by pressing
the on/off button for approx.
7 seconds (see chapter
'Replacement').
Replace the shaving heads
(see chapter 'Replacement').
Do not move the appliance
too fast.
Clean the cutting element
by rinsing it under the tap
with hot water. Switch on
the appliance and rinse the
cutting element once more
to remove any remaining
hairs.
If rinsing the nose trimmer
under the tap does not
unblock the cutting element,
then immerse it in a glass
with warm water for a few
minutes. Then switch on the
appliance and rinse it under
the tap.
35